36191195
construction of poondi two class rooml building poondi , part 1 : construction of 2 class room school building ( g sbc 150 kpa ) in panchayat union elemantary school @ poondi, h / o poondi. estimate amount rs. 39.60 lakhs. , earthwork excavation for foundation ( for narrow excavation ) to full depth as per designed in all soils and sub soils except soft disintegrated rock not requiring blasting and hard rock requiring blasting and bailing water wherever necessary. refilling the sides of foundation with excavated earth other than sand in layers of well rammed and compacted and depositing the surplus earth in places shown by the departmental officers with an initial lead of 10m and initial lift of 2m and clearing and leveling the site etc. complete complying with standard specification. , supplying and filling in foundations and basement with filling m sand in layers not exceeding 15 cm.thick, well watered, rammed and consolidated etc. complete complying with standard specifications. , plain cement concrete 1 : 4 :8 ( one part of cement, four parts of sand and eight parts of hard broken stone ) using 40 mm gauge hand broken hard broken granite stone jelly complying with standard specifications in foundations and basement. , refilling the approved good quality earth in plinths, area development etc. wherever specified in layers is not exceeding 200 mm thick, with available earth at site. , supplying and filling of good earth filling locally available earth transported from the outside including consolidation, leveling specifiedin layers of not exceeding 200 mm thick., etc. complete. , supplying and erecting centering and shuttering for soffits including necessary supports and strutting up to 3 m height for plane surfaces as detailed below in all floors with all cross bracings using mild steel sheets of size 90 x 60 cm and 10 bg stiffened with welded mild steel angle of size 25mm x 25mm x 3 mm for boarding laid over silver oak joists of size 10cm x 6.50 cm spaced at about90 cm centre to centre and supported by casurina props of 10cm to 13 cm dia spaced at not more than 75 cm centre to centre etc. complete complying with the standard specification. ( payment for centering shall be given after the concrete is laid ) . , footing, plinth beam, etc. , plain surfaces such as roof slab, floor slab, beams, lintels, loft, sill slab, staircase waist, portico slab and other similar works. , square and rectangular columns and small quantities such as sunshades, parapet cum drops, window boxing, fin projections and other similar works. , providing and laying in position, m 20 grade in accordance with is:456 2000, using 20mm and down grade hard broken granite stone jelly for all rcc items of works with minimum cement content of 350kg / m3 and maximum water cement ratio of 0.50, including admixture ( plasticiser / super plasticiser ) in recommended proportions as per is:9130 to accelerate, rated setting of concrete, improve workability without impairing strength and durability with about ( 5.0 cu.m ) 7730kg. of 20mm machine crushed stone jelly and with about ( 3.3cum ) 5156 kg. of 10 12mm machine crused stone jelly and with about ( 4.79cum ) 7670 kg of sand, but excluding cost of reinforcement grill and fabricating charges, centering and shuttering and also including laying, vibrating with mechanical vibrators, finishing, curing, etc., and providing fixtures like fan clamps in the rcc floor / roof slabs wherever necessary without claiming extra, etc., complete complying with standard specification and as directed by the departmental officers. the coarse and fine aggregates to be used should comply with the requirements of is standards. ( no separate payment will be made by the department for the excess usage of materials ) . , foundation & basement , ground floor , steel fe 500 d: supply, fabrication and placing of reinforcement steel of high yield strength ribbed bars of various diameters and grade conforming to is 1786 for reinforced concrete work. the work includes recoiling, straightening, cutting, bending, fabricating, and placing in position, at all levels including lead and lift, according to drawings, specifications etc. complete and supply & use of 18g black annealed binding wire double fold to tie the bars in position and providing precast cement / pvc cover blocks for main reinforcement to ensure specified cover and complete., including all labor charges etc as directed by departmental officers. , brick work in following cement mortar 1:5 using best quality ii class table moulded bricks 83 / 4 x 41 / 4 x23 / 4 for foundation and basement including curing etc., complete complying with standard specification.including scaffolding curing cost of reinforcement etc.all complete as per specifications and drawings as directed by the engineer in charge. , foundation basement , ground floor , brick partition walls of 11.50cm thickness using best qualityii class table moulded bricks 83 / 4 x 41 / 4 x23 / 4 in cement mortar 1:3 ( one cement and three sand ) using hoop iron reinforcement if found necessary including curing etc. complete and as directed by the departmental officers. , groundfloor , terrace floor , providing and applying 10 mm thick cement plaster in cement mortar 1:3 ( one part of cement and three parts of sand ) , to finishing the exposed surfaces of r.c.c. items of works such as roof ( or ) floor slabs, beams, and sun shades etc.to correct plane and level including scaffolding, hacking of surface, chiselling the undulated surface wherever necessary and curing etc., all materials and labour complete in all respects including all lead, lift and descent and as directed by the enineer in charge. this rate includes the cost of providing cement mortar beadings for sun shades, steps, landing slabs, elevation etc. complete complying with standard specifications. , providing & applying 12 mm thick cement plaster in cm 1:5 ( 1 part of cement: 5 parts of sand ) to walls internally in single coat at all levels to correct line and level including chicken wire mesh at all joints of brick and concrete surfaces with minimum overlap of 150 mm in all directions, scaffolding, rounding off or chambering of corners, offsets, fin / bands, projections, etc. and cleaning of surface, raking out joints, roughening of surface, chiseling the undulated surface wherever necessary and curing, etc., all materials and labor complete in all respects including all lead, lift and descent andas directed. , providing & applying 20 mm thick cement plaster in cm 1:5 ( 1 part of cement: 5 parts of sand ) to walls externally in single coat at all levels to correct line and level includingscaffolding, rounding off or chambering of corners, offsets, fin / bands, projections, etc. and cleaning of surface, raking out joints, roughening of surface, chiseling the undulated surface wherever necessary and curing, etc., all materials and labor complete in all respects including all lead, lift and descent andas directed. , paving the floor with best approved quality fine polished shahabadstone slabs of size 600 x 600 of 18 / 20mm with machine cut edges and matching marble slab not less than 100mm width other than adanga marbles as border laid over a cement mortar bed of 20mm thick using cement mortar 1:3 ( one cement and three sand ) fixing the slabs in true right angles with minimum possible width of joints and pointing the joints with white cement mixed with mathcing colouring pigments and polishing with floor polisher to a high degree of finish etc., the kota stone slabs and other materials to be used shall be got approved by the executive engineer concerned before use on work, etc., complete as per standard speicification , providing granolithic floor finish of the following thickness with plain cement concrete 1:2:4 ( one cement, two sand and four aggregate ) using 10 to 12mm gauge hard broken stone jelly including laying, finishing and the top rubbed smooth with power trawl, thread lining, curing etc. complete complying with standard specification and as directed by the departmental officers. ( the rate is inclusive of necessary planking for panellingwherever necessary and as directed by the departmental officers ) . , supplying and fixing in position steel balustrades using 20mm square rods spaced at 150mm centre to centre so that the two balustrades in each step shall be placed centrally and the top of balustrades connected with the hand rails ( cost of hand rail shall be measured and paid separately ) by means of ms flats of size 40mm x 6mm in the groove 40mm x 6mm provided at the bottom of hand rail; the bottom of balustrades shall be fixed on to the top of step concrete.an additional ms flat of size 50mm x 6mm shall be provided at the centre of balustrades connecting all square rods to the entire length including cost of square rods, flat and applying one coat of red oxide primer to the iron surfaces, etc., complete complying with standard specification and as directed by the departmental officers. , supplying and fixing 40mm dia gi pipe for staircase hand rail including labour charges for cutting, welding and fixing with ms flats ( excluding cost of flat ) , etc., as directed by the departmental officers , an ms square bar of 12mm size is welded to the inner face of the window at an equal interval not exceeding 100mm edge between them. all members are painted with one coat of anti corrosive red oxide primer as directed by the departmental officers.all sections should be in confirmed with is 7452 / 1990.the cost includes cost of all materials, labour charges and other incidental charges, etc., complete , manufacturing, supplying and fixing of steel doors with following specification.ms angle of size 40x40x6mm at 3.5 kg / m used for outer frame and ms angle of size 35x35x5mm at 2.6 kg / m for the shutter frame.stiffeners with 32x6mm at 1.5 kg / m ms flat is provided as the lock rail of the door and welded intact on both ends to the shutter frame.18 g cr sheets of best quality is laid as panel in the shutter frames.18x5mm at 0.70 kg / m ms flat is welded over the 32x6mm at 1.50kg / m ms flat on the rear side of the door, sandwiching the cr sheet for rigidity. additional stiffeners with 18x5mm at 0.7 kg / m ms flats are provided diagonally on the rear side of the shutter. 300mm length of hinges 2nos, for shutter is provided.6 nos. of 250mm length hold fasts 200mm length specified at the ends are welded to the outer frame of the door. tower bolt 2 nos. at the top provided. , supplying and painting new ceiling plastered surface with two coats of distempering one coat of distemper primer , supplying and painting new plastered internal wall surface with two coats of distempering one coat of distemper primer , supplying and painting the walls with one coat of wall primer and two coats of exterior emulsion ( apex or equivalent ) as instructed by the departmental officers including preparation of surface curing, etc., complete in all floors complying with standard specifications ( the colour and shade of the cement paint shall be got approved by the executive engineer before use of work ) . , weathering course concrete using best quality broken brick jelly of 20 mm uniform gauge in pure slaked lime ( no sand to be used ( over the rcc roof slab in the proportion of brick jelly to lime being 32 : 121 / 2 by volume laid over in single layer and consolidated to the required slope and finished thickness and beating the concrete with wooden beaters of approved pattern, keeping the surface constantly wet by sprinkling lime, jiggery water etc. complete complying with standard specifications and as directed , finishing the top of roof with one course of machine pressed tiles of size 230mm x 230mm x 20mm of approved quality set in cement mortar 1:3 ( one cement and three sand ) 12mm thick mixed with water proofing compound conforming to iss at 2% by weight of cement used and the joints pointed neatly to full depth of tiles with the same cement mortar mixed with red oxide and water proofing compound including curing etc., complete complying with standard specification and as directed by the departmental officers. , painting new iron works such as steel doors, windows, ventilators, window bars, balustrades etc., with two coats of best approved first quality and colour of synthetic enamel paint over the existing red oxide priming coat in all floors excluding cost of priming coat etc., complete complying with standard specification. ( the make, quality and colour of paint should be got approved by the executive engineer before use on works. ) , supplying and fixing cuddapah slab for cupboard shelf , providing cup board shutter with frame using termite / water proof plywood of 19mm thick over which laminated sheet of 0.8mm thick fixed inside the shutter and 1mm thick fixed in the outside of the shutter using fevicol along with necessary furniture fittings, such as, hydralic hinges, tower bolt, handles, multi purpose locks etc., as directed by the departmental officers. the design pattern, water proof plywood, laminate sheet and other materials should be got , supplying and fixing pvc rain water down fall pipes of following dia meter etc., complete. , bala painting , magnetic green fibre board , display notice board , shoe rack , windows acrylic sheet 6mm thick at bottom portion of steel window of size300mmx 1200mm ( 6 nos ) , drinking water pedestal with pvc tank , rainwater harvesting structure , quality control , tactile / braille sign board , sub estimate ( electrification ) , wiring 2 x 1.5 sq.mm ( 22 / 0.30 ) pvc insulated unsheathed sc.cu.conductor of 1100 v grade in suitable pvc rigid pipe on wall and ceiling with pvc accessories with tw switch box with in flush with wall covered with hylem sheet of 3 mm thick with painting of suitable colour for concealedpvc light / fan point ( sd no.25 ) , supply and fixing of4 18wled tube with fitting inclusive of all charges , wiring 2 x 1.5 sq.mm ( 22 / 0.30 ) pvc insulated unsheathedsc.cu. conductor of 1100 v grade in suitable pvc rigid pipe on wall and ceiling with pvc accessories with tw switch box with in flush with wall covered with hylem sheet of 3 mm thick with painting of suitable colour for concealedpvc plug point ( sd no.38 ) 5 pin plug point , supply and fixing of water tight bulk head fitting with guard ( philips / bajaj / crompton / klite ) suitable for incandencent lamp and 60w bulb ( sd n0.83 ) , supply and run of 2 of 1.50 sq.mm polythene insulated pvc sheathed heavy duty sc copper conductor of 1100 v grade on 7 / 20 gi bearer wire for service connection mains ( sd no.64 ) , supply and fixing of tneb meter board suitable for 32a single phase service connection with 32a fuse unit ( 500v ) 32a neutral link and earth link ( 1 x 1 / 8 copper flat ) on tw plank of size 375mm x 300mm x 19mm with supporting tw reepers of 1 thick an either side with painting with suitable bolt and nuts for fixing the tw plank on wall with earth connection and inter connection with 7 / 20 pvc insulated copper wire from eb meter to fuse unit. ( sd no. 125 ) , supply and run of 2x4 sqmm ( 22 / 0.3 ) pvc insulated sc unsheathed cu.conductor of 1100v grade in 25mm dia gi pipe ( class b ) suitably bent at both ends with necessary angle iron upright and end supports for mains sd 70 , supply and fixing of 16 amps dp switch of500v with metal clad with fuse and neutral sd 142 , sd 139 , sd 134 , sd 234 , provision for eb deposit charges , providing and fixing name board , gst amount for providing service to government contract works for the above construction works. { gst amount is the total gst amount for total overall quoted amount above this row in column bb for all works in this package } ...
Due Date : February 15, 2023
Tender Value : ₹ Ref. Documents
